CY7C63722C
CY7C63723C
CY7C63743C
enCoRe™ USB Combination Low-Speed
USB and PS/2 Peripheral Controller
1.0
Features
• enCoRe™ USB - enhanced Component Reduction
— Internal oscillator eliminates the need for an external
crystal or resonator
— Interface can auto-configure to operate as PS/2 or
USB without the need for external components to
switch between modes (no General Purpose I/O
[GPIO] pins needed to manage dual mode capability)
— Internal 3.3V regulator for USB pull-up resistor
— Configurable GPIO for real-world interface without
external components
• Flexible, cost-effective solution for applications that
combine PS/2 and low-speed USB, such as mice, game-
pads, joysticks, and many others.
• USB Specification Compliance
— Conforms to USB Specification, Version 2.0
— Conforms to USB HID Specification, Version 1.1
— Supports one low-speed USB device address and
three data endpoints
— Integrated USB transceiver
— 3.3V regulated output for USB pull-up resistor
• 8-bit RISC microcontroller
— Harvard architecture
— 6-MHz external ceramic resonator or internal clock
mode
— 12-MHz internal CPU clock
— Internal memory
— 256 bytes of RAM
— 8 Kbytes of EPROM
— Interface can auto-configure to operate as PS/2 or
USB
— No external components for switching between PS/2
and USB modes
— No GPIO pins needed to manage dual mode
capability
•
I/O ports
— Up to 16 versatile GPIO pins, individually
configurable
— High current drive on any GPIO pin: 50 mA/pin
current sink
— Each GPIO pin supports high-impedance inputs,
internal pull-ups, open drain outputs or traditional
CMOS outputs
— Maskable interrupts on all I/O pins
• SPI serial communication block
— Master or slave operation
— 2 Mbit/s transfers
• Four 8-bit Input Capture registers
— Two registers each for two input pins
— Capture timer setting with five prescaler settings
— Separate registers for rising and falling edge capture
— Simplifies interface to RF inputs for wireless
applications
• Internal low-power wake-up timer during suspend
mode
— Periodic wake-up with no external components
• Optional 6-MHz internal oscillator mode
— Allows fast start-up from suspend mode
• Watchdog Reset (WDR)
• Low-voltage Reset at 3.75V
• Internal brown-out reset for suspend mode
• Improved output drivers to reduce EMI
• Operating voltage from 4.0V to 5.5VDC
• Operating temperature from 0°C to 70°C
• CY7C63723C available in 18-pin SOIC, 18-pin PDIP
• CY7C63743C available in 24-pin SOIC, 24-pin PDIP,
24-pin QSOP
• CY7C63722C available in DIE form
• Industry standard programmer support
Cypress Semiconductor Corporation
Document #: 38-08022 Rev. *C
•
198 Champion Court
•
San Jose
•
CA 95134 • 408-943-2600
Revised February 25, 2006
CYPRESS [ CYPRESS SEMICONDUCTOR ]
