CY7C1345B
Single Write Accesses Initiated by ADSC
This write access is initiated when the following conditions are
satisfied at clock rise: (1) CE
1
, CE
2
, and CE
3
are all asserted
active, (2) ADSC is asserted LOW, (3) ADSP is deasserted
HIGH, and (4) the write input signals (GW, BWE, and BW
[3:0]
)
indicate a write access. ADSC is ignored if ADSP is active LOW.
The addresses presented are loaded into the address register
and the burst counter/control logic and delivered to the RAM
core. The information presented to DQ
[31:0]
will be written into
the specified address location. Byte writes are allowed. During
byte writes, BW
0
controls DQ
[7:0]
, BW
1
controls DQ
[15:8]
, BW
2
controls DQ
[23:16]
, and BWS
3
controls DQ
[31:24]
. All I/Os are
three-stated when a write is detected, even a byte write. Since
this is a common I/O device, the asynchronous OE input signal
must be deasserted and the I/Os must be three-stated prior to
the presentation of data to DQ
[31:0]
. As a safety precaution, the
data lines are three-stated once a write cycle is detected, re-
gardless of the state of OE.
Table 1. Counter Implementation for the Intel®
Pentium®/80486 Processor’s Sequence
First
Address
A
X + 1
, A
x
00
01
10
11
Second
Address
A
X + 1
, A
x
01
00
11
10
Third
Address
A
X + 1
, A
x
10
11
00
01
Fourth
Address
A
X + 1
, A
x
11
10
01
00
Table 2. Counter Implementation for a Linear Sequence
First
Address
A
X + 1
, A
x
00
01
10
11
Sleep Mode
The ZZ input pin is an asynchronous input. Asserting ZZ HIGH
places the SRAM in a power conservation “sleep” mode. Two
clock cycles are required to enter into or exit from this “sleep”
mode. While in this mode, data integrity is guaranteed. Ac-
cesses pending when entering the “sleep” mode are not con-
sidered valid nor is the completion of the operation guaran-
teed. The device must be deselected prior to entering the
“sleep” mode. CE
1
, CE
2
, CE
3
, ADSP and ADSC must remain
,
inactive for the duration of t
ZZREC
after the ZZ input returns
LOW. Leaving ZZ unconnected defaults the device into an ac-
tive state.
Second
Address
A
X + 1
, A
x
01
10
11
00
Third
Address
A
X + 1
, A
x
10
11
00
01
Fourth
Address
A
X + 1
, A
x
11
00
01
10
Burst Sequences
The CY7C1345B provides an on-chip 2-bit wraparound burst
counter inside the SRAM. The burst counter is fed by A
[1:0]
,
and can follow either a linear or interleaved burst order. The
burst order is determined by the state of the MODE input. A
LOW on MODE will select a linear burst sequence. A HIGH on
MODE will select an interleaved burst order. Leaving MODE
unconnected will cause the device to default to a interleaved
burst sequence.
5
CYPRESS [ CYPRESS SEMICONDUCTOR ]
