+/+…when timing is critical
C9829B
Low EMI Clock Generator for Intel 133MHz/3DIMM Chipset Systems
Approved Product
Power on Bi-Directional Pins
Power Up Condition:
Pins 4, 14, 30 are Power up bi-directional pins and are used for selecting the host frequency in page 1, table 1. During
power-up of the device, these pins are in input mode (see Fig 4, below), therefore; they are considered input select pins,
Sel(1:3) internal to the IC. After a settling time, the selection data is latch into the internal control register and these pins
become a clock output.
VDD Rail
Power Supply
Ramp
REF / SEL1(Pin 4)
PCI0 / SEL3 (Pin14)
USB / SEL2 (30)
-
Hi-Z Inputs
Toggle Outputs
Select Data is latched into register, then pin becomes a clock output signal.
Fig.4
Vdd
R up
Strapping Resistor Options:
The power up bi-directional pins have a large value pull-
down (50KΩ+/−20KΩ), therefore, a selection “0” is the
default. If the system uses a slow power supply (over
10mS settling time), then it is recommended to use an
external Pull-down (Rdn) in order to insure a low
selection. In this case, the designer may choose one of
two configurations, see Fig.5A and B.
1K
IM I C 9829
R d
Load
Bidirectional
JP1
JU MPER
Fig. 5A
R dn
5K
Fig. 5A represents an additional pull down resistor 5KΩ
connected from the pin to the power line, which allows a
faster down to a high level.
If a selection “1” is desired, then a jumper is placed on
JP1 to a 1 KΩ resistor as shown in Fig.5A. Please note
the selection resistors (Rup and Rdn) are placed before
the Damping resistor (Rd) close to the pin.
JP2
3 W ay Jum per
Vdd
3
2
1
Fig. 5B represent a single resistor 5KΩ connected to a
3-way jumper, JP2. When a “1” selection is desired, a
jumper is placed between leads1 and 3. When a “0”
selection is desired, a jumper is placed between leads 1
and 2.
R sel
5K
IM I C 9829
R d
Load
Bidirectional
Fig. 5B
INTERNATIONAL MICROCIRCUITS, INC. 525 LOS COCHES ST.,
MILPITAS, CA 95035, USA. TEL: 408-263-6300, FAX 408-263-6571
http://www.imicorp.com
Rev 1.3
4/12/2000
Page 6 of 20