BCM88335 Data Sheet
Bluetooth RF Specifications
Table 27: Bluetooth Receiver RF Specifications (Cont.)
Conditions Minimum Typical
Parameter
Maximum Unit
Spurious Emissions
30 MHz–1 GHz
1–12.75 GHz
–
–
–
–
–
–
–
–95
–62
–47
–
dBm
–70
dBm
851–894 MHz
925–960 MHz
1805–1880 MHz
1930–1990 MHz
2110–2170 MHz
–147
–147
–147
–147
–147
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
–
–
–
–
a. The maximum value represents the actual Bluetooth specification required for Bluetooth qualification as defined
in the version 4.1 specification.
b. Bluetooth reference level is taken at the 3 dB RX desense on each of the modulation schemes.
c. Interferer: 2380 MHz, BW=10 MHz; measured at 2480 MHz.
d. Interferer: 2355 MHz, BW=10 MHz; measured at 2480 MHz.
e. Interferer: 2560 MHz, BW=10 MHz; measured at 2480 MHz.
f. Interferer: 2360 MHz, BW=10 MHz; measured at 2402 MHz.
Table 28: Bluetooth Transmitter RF Specifications
Parameter
Conditions
Minimum Typical Maximum Unit
Note: The specifications in this table are measured at the chip port output unless otherwise specified.
General
Frequency range
2402
11.0
–
2480
–
MHz
dBm
Basic rate (GFSK) TX power at Bluetootha
13.0
QPSK TX Power at Bluetootha
8PSK TX Power at Bluetooth
8.0
10.0
–
dBm
8.0
2
10.0
4
–
8
dBm
dB
Power control step
Note: Output power is with TCA and TSSI enabled.
GFSK In-Band Spurious Emissions
–20 dBc BW
–
–
0.93
1
MHz
EDR In-Band Spurious Emissions
1.0 MHz < |M – N| < 1.5 MHz
M – N = the frequency range for –
–38
–31
–43
–26.0
–20.0
–40.0
dBc
which the spurious emission is
1.5 MHz < |M – N| < 2.5 MHz
–
–
dBm
dBm
measured relative to the
transmit center frequency.
|M – N| 2.5 MHzb
Broadcom®
September 23, 2015 • 88335-DS100-R
Page 97
BROADCOM CONFIDENTIAL
CYPRESS [ CYPRESS ]
