BCM43907 Preliminary Data Sheet
WLAN Current Consumption
d. REG_ON is low or the device is in hibernation, and all supplies are present.
e. REG_ON is high. APPS domain is powered down. WLAN domain is in low-power state retention mode. Top level
is powered up.
f. Inter-beacon current.
g. Beacon Interval = 102.4 ms. Beacon duration = 1 ms @ 1 Mbps. Average current over 3× DTIM intervals.
h. Beacon interval = 307.2 ms. Beacon duration = 1 ms @ 1 Mbps. Average current over 3× DTIM intervals.
i. Duty cycle is 100%. Carrier sense (CS) detect/packet receive.
j. Measured using packet engine test mode.
k. Carrier sense (CCA) when no carrier present.
l. Duty cycle is 100%.
5 GHz Mode
Table 38: 5 GHz Mode WLAN Current Consumption
VDDIO= VDDIO_HIB
VBAT = 3.6V a
(µA)
= 3.3V a, b, c
(µA)
Mode
Sleep Modes
d
3
3
Radio off
e, f
6
160
160
160
160
Sleep
g
h
1390
470
160
IEEE Power Save, DTIM=1, single RX, APPS powered down
IEEE Power Save, DTIM=3, single RX, APPS powered down
IEEE Power Save, DTIM=9, single RX, APPS powered down
Active Modes
i, j
i, j
72,400
84,700
70,200
79,500
326,000
311,000
60
60
60
60
60
60
Continuous RX mode MCS7, HT20, 1SS, APPS powered up
Continuous RX mode MCS7, HT40, 1SS, APPS powered up
k
CRS-HT20, APPS powered up
k
CRS-HT40, APPS powered up
l
l
Continuous TX mode MCS7, HT20, 1SS, 1 TX, APPS powered up
Continuous TX mode MCS7, HT40, 1SS, 1 TX, APPS powered up
Ping Modes
l
327,000
6
60
Ping to associated access point
Sleep
160
a. Typical silicon.
b. VIO is specified with all pins idle (not switching) and not driving any loads.
c. Excludes VDDIO_USB, VDDIO_RMII, VDDIO_I2S, and VDDIO_SD.
d. REG_ON is low or the device is in hibernation, and all supplies are present.
e. REG_ON is high. APPS domain is powered down. WLAN domain is in low-power state retention mode. Top level
is powered up.
f. Inter-beacon current.
g. Beacon Interval = 102.4 ms. Beacon duration = 1 ms @ 1 Mbps. Average current over 3× DTIM intervals.
h. Beacon interval = 307.2 ms. Beacon duration = 1 ms @ 1 Mbps. Average current over 3× DTIM intervals.
i. Duty cycle is 100%. Carrier sense (CS) detect/packet receive.
j. Measured using packet engine test mode.
Broadcom®
March 12, 2016 • 43907-DS104-R
Page 97
BROADCOM CONFIDENTIAL