BCM4354 Data Sheet
FM Receiver Specifications
Section 16: FM Receiver Specifications
Note: Values in this data sheet are design goals and are subject to change based on the results of
device characterization.
Unless otherwise stated, limit values apply for the conditions specified inTable 30: “Environmental Ratings,” on
page 126 and Table 32: “Recommended Operating Conditions and DC Characteristics,” on page 127. Typical
values apply for an ambient temperature +25°C.
Table 37: FM Receiver Specifications
Typica
Parameter
Conditionsa
Minimum l
Maximum Units
RF Parameters
Operating frequencyb
Sensitivityc
Frequencies inclusive
65
–
–
108
–
MHz
FM only
SNR ≥ 26 dB
0
dBµV
EMF
–
–
–
1
–
–
–
µV EMF
dBuV
dB
–6
51
Receiver adjacent
channel selectivityc,d
Measured for 30 dB SNR at the audio
output.
Wanted Signal: 23 dBµV EMF (14.1 µV
EMF), at ± 200 kHz.
At ± 400 kHz
–
62
53
–
–
dB
dB
Intermediate signal plus Vin = 20 dBµV EMF (10 µV EMF)
noise-to-noise ratio (S+N)/
45
N, stereoc
Intermodulation
performancec,d
Blocker level increased until desired at
30 dB SNR
Wanted Signal: 33 dBµV EMF (45 µV
–
55
–
dBc
EMF)
Modulated Interferer: At fWanted
±400 kHz and ±4 MHz
CW Interferer: At fWanted ± 800 kHz and
±8 MHz
AM suppression, monoc
Vin = 23 dBµV EMF (14.1 µV EMF)
AM at 400 Hz with m = 0.3
No A-weighted or any other filtering
applied.
40
–
–
dB
Broadcom®
October 15, 2014 • 4354-DS109-R
Page 135
BROADCOM CONFIDENTIAL