CYW4343X
Table 33. WLAN 2.4 GHz Transmitter Performance Specifications (Cont.)
Parameter
Condition/Notes
Minimum Typical Maximum
Unit
Harmonic level (at 21 dBm with 4.8–5.0 GHz
2nd harmonic
3rd harmonic
4th harmonic
–
–
–
–26.5
–23.5
–32.5
–
–
–
dBm/ MHz
dBm/ MHz
dBm/ MHz
90% duty cycle, 1 Mbps CCK)
7.2–7.5 GHz
9.6–10 GHz
TX power at the chip port for the
highest power level setting at
25°C, VBA = 3.6V, and spectral
mask and EVM complianceb, c
–
EVM Does Not Exceed
IEEE 802.11b
(DSSS/CCK)
–9 dB
21
–
–
dBm
OFDM, BPSK
OFDM, QPSK
OFDM, 16-QAM
–8 dB
20.5
20.5
20.5
18
–
–
–
–
–
–
–
–
dBm
dBm
dBm
dBm
–13 dB
–19 dB
–25 dB
OFDM, 64-QAM
(R = 3/4)
OFDM, 64-QAM
(R = 5/6)
–27 dB
17.5
15
9
–
–
–
–
–
dBm
dBm
dB
OFDM, 256-QAM(R= –32 dB
5/6)
–
TX power control
dynamic range
–
–
Closed loop TX power variation at Across full temperature and voltage range. Applies
–
±1.5
dB
highest power level setting
Carrier suppression
Gain control step
Return loss
across 5 to 21 dBm output power range.
–
15
–
–
–
–
–
–
–
–
–
–
–
dBc
dB
–
0.25
6
Zo = 50
4
dB
Load pull variation for output
power, EVM, and Adjacent
Channel Power Ratio (ACPR)
VSWR = 2:1.
VSWR = 3:1.
EVM degradation
–
3.5
±2
15
4
dB
Output power variation
–
dB
ACPR-compliant power level –
dBm
dB
EVM degradation
–
–
Output power variation
±3
15
dB
ACPR-compliant power level –
dBm
a. The cellular standards listed indicate only typical usages of that band in some countries. Other standards may also be used within those bands.
b. TX power for channel 1 and channel 11 is specified separately by nonvolatile memory parameters to ensure band-edge compliance.
c. Optimal RF performance, as specified in this data sheet, is guaranteed only for temperatures between –10°C and 55°C.
16.4 General Spurious Emissions Specifications
Table 34. General Spurious Emissions Specifications
Parameter
Condition/Notes
Minimum
2400
General Spurious Emissions
Typical
Maximum
2500
Unit
MHz
Frequency range
–
–
TX emissions
30 MHz < f < 1 GHz
RBW = 100 kHz
RBW = 1 MHz
RBW = 1 MHz
RBW = 1 MHz
RBW = 100 kHz
RBW = 1 MHz
RBW = 1 MHz
RBW = 1 MHz
–
–
–
–
–
–
–
–
–99
–44
–68
–88
–99
–54
–88
–88
–96
–41
–65
–85
–96
–51
–85
–85
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
1 GHz < f < 12.75 GHz
1.8 GHz < f < 1.9 GHz
5.15 GHz < f < 5.3 GHz
30 MHz < f < 1 GHz
RX/standby
emissions
1 GHz < f < 12.75 GHz
1.8 GHz < f < 1.9 GHz
5.15 GHz < f < 5.3 GHz
Note: The specifications in this table apply at the chip port.
Document No. 002-14797 Rev. *H
Page 96 of 128