PRELIMINARY
CYW43438
Table 31. Bluetooth Transmitter RF Specifications1 (Cont.)
Parameter
Conditions
Minimum Typical Maximum
Unit
Out-of-Band Noise Floor7
65–108 MHz
FM RX
–
–
–
–
–
–
–
–
–147
–146
–146
–146
–146
–144
–143
–137
–
–
–
–
–
–
–
–
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
776–794 MHz
869–960 MHz
925–960 MHz
1570–1580 MHz
1805–1880 MHz
1930–1990 MHz
2110–2170 MHz
CDMA2000
cdmaOne, GSM850
E-GSM
GPS
GSM1800
GSM1900, cdmaOne, WCDMA
WCDMA
1. Unless otherwise specified, the specifications in this table apply at the chip output port, and output power specifications are with the
temperature correction algorithm and TSSI enabled.
2. Typically measured at an offset of ±3 MHz.
3. The maximum value represents the value required for Bluetooth qualification as defined in the v4.1 specification.
4. The spurious emissions during Idle mode are the same as specified in Table 31.
5. Specified at the Bluetooth antenna port.
6. Meets this specification using a front-end band-pass filter.
7. Transmitted power in cellular and FM bands at the Bluetooth antenna port. See Figure 34 for location of the port.
Table 32. LTE Specifications for Out-of-Band Noise Floor
Parameter
Conditions
Typical
–130
–130
–130
–130
Unit
2500–2570 MHz
2300–2400 MHz
2570–2620 MHz
2545–2575 MHz
Band 7
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
Band 40
Band 38
XGP Band
Table 33. Local Oscillator Performance
Parameter
Minimum
Typical
Maximum
Unit
LO Performance
Frequency Drift
Lock time
–
–
72
–
s
Initial carrier frequency tolerance
±25
±75
kHz
DH1 packet
DH3 packet
DH5 packet
Drift rate
–
–
–
–
±8
±8
±8
5
±25
±40
±40
20
kHz
kHz
kHz
kHz/50 μs
Frequency Deviation
00001111 sequence in payload1
10101010 sequence in payload2
Channel spacing
140
115
–
155
140
1
175
–
kHz
kHz
MHz
–
1. This pattern represents an average deviation in payload.
2. Pattern represents the maximum deviation in payload for 99.9% of all frequency deviations.
Document Number: 002-14796 Rev. *K
Page 78 of 101
CYPRESS [ CYPRESS ]
