PRELIMINARY
CYW43438
Table 27. WLAN 2.4 GHz Transmitter Performance Specifications (Cont.)
Parameter
TX power control
Condition/Notes
Minimum Typical Maximum
Unit
dB
–
9
–
–
–
–
dynamic range
Across full temperature and voltage range.
Applies across 5 to 21 dBm output power
range.
Closed loop TX power variation at
highest power level setting
±1.5
dB
Carrier suppression
Gain control step
Return loss
–
15
–
–
–
–
–
–
–
dBc
dB
dB
dB
dB
–
0.25
6
Zo = 50
4
EVM degradation
–
3.5
±2
Output power variation
–
VSWR = 2:1.
ACPR-compliant power
level
–
15
–
dBm
Load pull variation for output power,
EVM, and Adjacent Channel Power
Ratio (ACPR)
EVM degradation
–
–
4
–
–
dB
dB
Output power variation
±3
VSWR = 3:1.
ACPR-compliant power
level
–
15
–
dBm
1. The cellular standards listed indicate only typical usages of that band in some countries. Other standards may also be used within those
bands.
2. TX power for channel 1 and channel 11 is specified separately by nonvolatile memory parameters to ensure band-edge compliance.
3. Optimal RF performance, as specified in this data sheet, is guaranteed only for temperatures between –10°C and 55°C.
16.4 General Spurious Emissions Specifications
Table 28. General Spurious Emissions Specifications
Parameter
Condition/Notes
Minimum
Typical
Maximum
Unit
Frequency range
–
2400
–
2500
MHz
General Spurious Emissions
RBW = 100 kHz
RBW = 1 MHz
30 MHz < f < 1 GHz
–
–
–
–
–
–
–
–
–99
–44
–68
–88
–99
–54
–88
–88
–96
–41
–65
–85
–96
–51
–85
–85
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
1 GHz < f < 12.75 GHz
1.8 GHz < f < 1.9 GHz
5.15 GHz < f < 5.3 GHz
30 MHz < f < 1 GHz
TX emissions
RBW = 1 MHz
RBW = 1 MHz
RBW = 100 kHz
RBW = 1 MHz
1 GHz < f < 12.75 GHz
1.8 GHz < f < 1.9 GHz
5.15 GHz < f < 5.3 GHz
RX/standby
emissions
RBW = 1 MHz
RBW = 1 MHz
Note: The specifications in this table apply at the chip port.
Document Number: 002-14796 Rev. *K
Page 73 of 101