PRELIMINARY
CYW43340
Table 26. Bluetooth Transmitter RF Specificationsa
Parameter Conditions
General
Minimum
Typical
Maximum
Unit
Frequency range
2402
–
2480
MHz
Basic rate (GFSK) TX power at Bluetooth
QPSK TX Power at Bluetooth
8PSK TX Power at Bluetooth
Power control step
–
–
–
2
11.0
8.0
8.0
4
–
–
–
8
dBm
dBm
dBm
dB
GFSK In-Band Spurious Emissions
–20 dBc BW
–
–
.93
1
MHz
EDR In-Band Spurious Emissions
1.0 MHz < |M – N| < 1.5 MHz
1.5 MHz < |M – N| < 2.5 MHz
|M – N| 2.5 MHzb
M – N = the frequency range for which –
–38
–31
–43
–26.0
–20.0
–40.0
dBc
the spurious emission is measured
relative to the transmit center
–
dBm
dBm
–
frequency.
Out-of-Band Spurious Emissions
30 MHz to 1 GHz
–
–
–
–
–
–
–
–
–
–36.0 c,d
–30.0 d,e,f
–47.0
dBm
dBm
dBm
dBm
1 GHz to 12.75 GHz
1.8 GHz to 1.9 GHz
5.15 GHz to 5.3 GHz
–
–
–
–47.0
GPS Band Spurious Emissions
Spurious emissions
–
–
–103
–
dBm
Out-of-Band Noise Floorg
65–108 MHz
FM RX
–
–147
–147
–147
–147
–146
–145
–144
–141
–
–
–
–
–
–
–
–
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
dBm/Hz
776–794 MHz
869–960 MHz
925–960 MHz
1570–1580 MHz
1805–1880 MHz
1930–1990 MHz
2110–2170 MHz
CDMA2000
–
–
–
–
–
–
–
cdmaOne, GSM850
E-GSM
GPS
GSM1800
GSM1900, cdmaOne, WCDMA
WCDMA
a. Unless otherwise specified, the specifications in this table are measured at the chip output port, and output power specifications are with the temperature
correction algorithm and TSSI enabled.
b. Typically measured at an offset of ±3 MHz.
c. The maximum value represents the value required for Bluetooth qualification as defined in the v4.0 specification.
d. The spurious emissions during Idle mode are the same as specified in Table 26 on page 65.
e. Specified at the Bluetooth Antenna port.
f. Meets this specification using a front-end band-pass filter.
g. Transmitted power in cellular and FM bands at the Bluetooth Antenna port. See Figure 28 on page 60 for location of the port.
Document Number: 002-14943 Rev. *L
Page 65 of 96