BCM20707 Preliminary Data Sheet
Microprocessor Unit
External Reset
An external active-low reset signal, RESET_N, can be used to put the BCM20707 in the reset state. An external
voltage detector reset IC with 50 ms delay is needed on the RESET_N. The RESET_N should be released only
after the VDDO supply voltage level has been stabilized for 50 ms.
Figure 2: Reset Timing
Low
threshold
50 ms
Reset
(External)
VDDO
~2.4 ms
VDDO POR
VDDC
0.5 ms
~2.4 ms
VDDC Reset (Internal)
XTAL_RESET
XTAL_BUF_PU
10 LPO cycles
8 LPO cycles
Note: The Reset signal should remain below this threshold 50 ms after VDDO is stable. Note that the
representation of this signaling diagram is extended and not drawn to scale.
Broadcom®
May 27, 2016 • 20707-DS206-R
Bluetooth SoC
Page 13
BROADCOM CONFIDENTIAL
CYPRESS [ CYPRESS ]
