EnerChip CC CBC3112
Electrical Properties
EnerChip Backup Output voltage:
Energy Capacity (typical):
Recharge time to 80%:
Charge/Discharge cycles:
3.3V
12µAh
10 minutes
>5000 to 10% discharge
Package size:
Operating temperature:
Storage temperature:
Physical Properties
7 mm x 7 mm
-20°C to +70°C
-40°C to +125°C (prior to 1st charge)
Functional Block Diagram
The EnerChip CC internal schematic is shown in Figure 2. The input voltage from the power supply (V
DD
) is
applied to the charge pump, the control logic, and is compared to the user-set threshold as determined by the
voltage on V
MODE
. V
MODE
is an analog input ranging from 0V to V
DD
. The ENABLE pin is a digital input that turns
off the charge pump when low. V
OUT
is either supplied from V
DD
or the integrated EnerChip. RESET is a digital
output that, when low, indicates V
OUT
is being sourced by the integrated EnerChip.
C
FLY
is the flying capacitor in the voltage doubler circuit. The value of C
FLY
can be changed if the output
impedance of the EnerChip CC needs to be modified. The output impedance is dictated by
1/fC,
where
f
is the
frequency of oscillation (typically 100kHz) and
C
is the capacitor value (typically 0.1µF). GND is system ground.
Figure 2: EnerChip CC CBC3112 Internal Block Diagram
©2009-2013 Cymbet Corporation • Tel: +1-763-633-1780 • www.cymbet.com
DS-72-04 Rev F
Page 2 of 16