page
date
3 of 5
11/12/2007
PART NUMBER: CPE-270
DESCRIPTION: piezo audio indicators
MECHANICAL CHARACTERISTICS
item
test condition
evaluation standard
solderability
Stripped wires are immersed in rosin for
5 seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
90% min. of the lead terminals
will be wet with solder
(except the edge of the terminal).
lead wire pull strength
vibration
The pull force shall be applied to lead wire:
Horizontal
Vertical
3.0N for 30 seconds No damage or cutting off.
2.0N for 30 seconds
The buzzer shall be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
The value of oscillation
frequency/current consumption
should be ±10% of the initial
measurements. The SPL should
be within ±10dB compared with
the initial measurement.
drop test
ENVIRONMENT TEST
item
test condition
evaluation standard
high temp. test
After being placed in a chamber at +95°C for
240 hours.
low temp. test
humidity test
After being placed in a chamber at -40°C for
240 hours.
After being placed in a chamber at +40°C and
90±5% relative humidity for 240 hours.
The part shall be subjected to 5 cycles. One
cycle will consist of:
temp. cycle test
The buzzer will be measured after
being placed at +25°C for 4
hours. The value of the
oscillation frequency/current
consumption should be ±10%
compared to the initial
+95
+25
+25
measurements. The SPL should
be within ±10dB compared to the
initial measurements.
-40
0.5hr 0.5hr 0.25 0.5hr 0.5hr 0.5hr 0.25
3hours
th
20050 SW 112 Ave. Tualatin, Oregon 97062 phone 503.612.2300 fax 503.612.2383
CUI [ CUI INC ]
