Crane Aerospace & Electronics Power Solutions
sFMc28-461 eMi input Filter cases
28 Volt input – 2.7 AMp
BOTTOM VIEW CASE K2
Flanged cases: Designator “F” required in Case Option position of model number.
Seam Seal
0.040 dia
(1.02)
1.110 max. (28.19)
0.955 (24.26)
Dot on top of case indicates pin one
1
0.555 (14.1)
5
2
3
0.162 dia
(4.11)
0.155 (3.94)
0.000
4
0.245 (6.22)
1.845 (46.86)
2.090 (53.01)
0.230 (5.84)
2.320 (58.93)
Seal hole: 0.120 ±0.002 (3.05 ±0.05)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header Cold Rolled Steel/Nickel/Gold
Cover Kovar/Nickel
Pins
#52 alloy/Gold ceramic seal
Case K2, Rev C, 20060110
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
F
Igure
7: C
aSe
K1
www.craneae.com
Page 8 of 11
Rev D - 20070404
2.910 max. (73.91)
0.400 max.
(10.16)
0.25 ±0.03
(6.4 ±0.8)
0.000
0.000