F
EATURES
• Adapts Interpoint “U1” cases
to upleaded or downleaded
configurations
• For use with MFL, MFLHP, MHP,
FMD270, HUM-70, or LCM Series
of Interpoint products
• Low resistance
• Copper alloy with solder plating
over nickel
A
CCESSORY
PIN
T
ERMINAL
A
DAPTOR
PIN
ADAPTOR
MODEL
PIN-001
PIN-001 adaptor dimensions are on the following page.
DESCRIPTION
Interpoint’s side-leaded packages can now be adapted with PIN
terminal adapters to fit a variety of configurations. These versatile
adapters slide over the ends of side-leaded package terminals and
are intended to be soldered to the leads to provide an up-leaded or
down-leaded configuration.
S
OLDERING
To prevent unwanted solder reflow, Interpoint suggests the use of
SN 96 (high-temp solder) to connect the PIN to the converter
terminal and SN 62 to connect the PIN to the board. The soldering
restrictions referenced on the data sheets of the listed Interpoint
products are 300°C for a maximum of 10 seconds per terminal.
C
ONSTRUCTION
PIN adapters are constructed from low resistance copper alloy Cu-
70210 which has a conductivity similar to that of copper. The plating
is 50 microinches (0.12mm) of solder — 60% tin and 40% lead —
over 100 to 200 microinches (2.5 to 5mm) of electrolytic nickel
plating.
A
PPLICATION
PIN terminal adapters are compatible with the following Interpoint
products:
MFL Series DC/DC converters
MFLHP Series DC/DC converters
MHP Series DC/DC converters
FMD-461SL, side-leaded DC/DC converter
LCM Line Conditioning Module
HUM-70 Hold-Up Module
L
OW
R
ESISTANCE
Low resistance copper alloy construction minimizes the voltage drop
across the PIN terminals. For example, when operating the
MFL2805S at full load (10 A) the voltage drop over the full length of
the adapter on positive Vout is just 30 mV. On single output
converter models, the sense function can compensate for even this
small drop if required.
B7-3
CRANE [ Crane Aerospace & Electronics. ]
