Crane Aerospace & Electronics Power Solutions
MTR Single, Dual and Triple DC/DC Converter Cases
28 VOLT INPUT – 30 WATT
BOTTOM VIEW CASE H2
Platform
Seam Seal
1.110 max. (28.19)
0.955 (24.26)
0.040 dia
(1.02)
Squared corner and dot on top
of case indicate pin one.
1
2
3
4
5
10
0.155 (3.94)
0.000
0.000
0.400 max.
(10.16)
0.000
0.245 (6.22)
9
8
7
6
0.645 (16.38)
1.045 (26.54)
1.445 (36.70)
1.845 (46.86)
5
6
1.845 (46.86)
Seal hole: 0.120 ±0.002 (3.05 ±0.05)
Squared corner and dot on top
of case indicate pin one.
1.110 max. (28.19)
0.955 (24.26)
1
2
3
4
10
0.155 (3.94)
0.000
0.000
0.245 (6.22)
9
8
7
0.645 (16.38)
1.045 (26.54)
1.445 (36.70)
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header
Cold Rolled Steel/Nickel/Gold
Cover
Kovar/Nickel
Pins
#52 alloy/Gold ceramic seal
Case H2, Rev C - 20060109
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
F
IGURE
33: C
ASE
H2 – D
UAL
M
ODELS
www.craneae.com
Page 13 of 19
Rev G - 20060505
2.090 max. (53.01)
2.090 max. (53.01)
0.25 (6.4)