Crane Aerospace & Electronics Power Solutions
MHF+ Single, Dual and Triple DC/DC Converter Cases
28 VOLT INPUT – 15 WATT
BOTTOM VIEW CASE G2
Flanged cases: Designator "F" required in Case Option position of model number
Projection Weld
Seam Seal
Squared corner and dot on top
of case indicate pin one.
1.130 max. (28.70)
0.960 (24.38)
1
2
3
4
5
0.128 dia
(3.25)
0.030 dia.
(0.76)
0.560
(14.22)
9
8
7
6
0.160
(4.06)
0.000
Flange thickness: 0.047 (1.19)
Seal hole: 0.080 0.002 (2.03 0.05)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
2.005 max
(50.93)
0.01 (0.3) for tꢀo decimal places
unless otherꢀise specified
CAUTION
Heat from refloꢀ or ꢀave soldering may damage the device.
Solder pins individually ꢀith heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header
Cover
Pins
Cold Rolled Steel/Nickel/Gold
Kovar/Nickel
#52 alloy/Gold compression glass seal
Case G2, Rev C, 20060111
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications ꢀithout notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
FIGURE 34: CASE G2 — TRIPLE MODELS
www.craneae.com
Page 18 of 20
Rev K - 20060613