Crane Aerospace & Electronics Power Solutions
MHF+ Single, Dual and Triple DC/DC Converter Cases
28 VOLT INPUT – 15 WATT
BOTTOM VIEW CASE G1
Flanged cases: Designator "F" required in Case Option position of model number
Projection Weld
Seam Seal
Squared corner and dot on top
of case indicate pin one.
0.960
(24.38)
1
2
3
4
5
0.030 dia.
(0.76)
0.128 dia
(3.25)
0.030 dia.
(0.76)
0.560
(14.22)
8
7
6
0.160
(4.06)
0.000
Seal hole: 0.080 0.002 (2.03 0.05)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
0.01 (0.3) for tꢀo decimal places
unless otherꢀise specified
CAUTION
Heat from refloꢀ or ꢀave soldering may damage the device.
Solder pins individually ꢀith heat application not exceeding 300°C for 10 seconds per pin.
Case G1, Rev B, September 23, 2005
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications ꢀithout notice.
Copyright © 1999-2005 Interpoint Corp. All rights reserved.
FIGURE 34: CASE G1 — SINGLE AND DUAL MODELS
www.craneae.com
Page 17 of 20
Rev K - 20060613