Crane Aerospace & Electronics Power Solutions
MHF+ Single, Dual and Triple DC/DC Converter Cases
28 VOLT INPUT – 15 WATT
BOTTOM VIEW CASE E1
Projection Weld
Seam Seal
Squared corner and dot on top
of case indicate pin one.
1.130 max. (28.70)
0.960 (24.38)
1
2
3
4
5
0.030 dia.
(0.76)
0.030 dia.
(0.76)
8
7
6
0.160 (4.06)
0.000
Seal hole: 0.080 0.002 (2.03 0.05)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
0.01 (0.3) for tꢀo decimal places
unless otherꢀise specified
CAUTION
Heat from refloꢀ or ꢀave soldering may damage the device.
Solder pins individually ꢀith heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header
Cover
Pins
Cold Rolled Steel/Nickel/Gold
Kovar/Nickel
#52 alloy/Gold compression glass seal
Case E1, Rev C, 20060111
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications ꢀithout notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
FIGURE 32: CASE E1— SINGLE AND DUAL MODELS
www.craneae.com
Page 15 of 20
Rev K - 20060613