MHE SERIES
20 WATT
Pin
1
2
3
4
5
6
7
8
9
10
Single Output
Positive Input
Inhibit
Output Adjust
Output Common
Positive Output
No connection
No connection
Case Ground
No connection
Input Common
DC/DC C
ONVERTERS
PIN OUT
Dual Output
Positive Input
Inhibit
Positive Output
Output Common
Negative Output
No connection
No connection
Case Ground
No connection
Input Common
Squared corner and dot on
top of cover indicate pin one.
1
2
3
4
5
BOTTOM VIEW
MHE
10
9
8
7
6
Dotted line outlines flanged package option.
See Section B8, case H6 and K7 for dimensions.
F
IGURE
1: P
IN
O
UT
MODEL NUMBERING KEY
MHE
Base Model
Input Voltage
Output Voltage
Number of Outputs
(S = single, D = dual)
Case Option
(Non-flanged case has no designator in
this position)
Screening
(Standard screening has no designator
in this position.)
28 12 S
F / ES
OUTPUT ADJUSTMENT RESISTOR VALUES
FOR MHE2805S AND MLP2805S
Resistance
Pin 3 to 4
Output Voltage
Increase (%)
0
+1%
+2%
+3%
+4%
+5%
∞
390K
145K
63K
22K
0
Output Adjustment all single output models:
The output can be adjusted upward by using the output
adjust (pin3). The resistance between output adjust (pin 3)
and output common (pin 4) will determine the magnitude of
the increase in the output.
The table above is applicable
only to MHE2805S.
4
MHE Series Rev D 20060630
All technical information is believed to be accurate, but no responsibility is assumed for
errors or omissions. Interpoint reserves the right to make changes in products or spec-
ifications without notice. MHE Series is a trademark of Interpoint Corporation.
Copyright © 1995 - 2006 Interpoint Corporation. All rights reserved.
CRANE [ Crane Aerospace & Electronics. ]
