Crane Aerospace & Electronics Power Solutions
MCH/MGH Single and Dual DC/DC Converter Cases
28 VOLT INPUT – 1.5 WATT
BOTTOM VIEW CASE A2
Projection Weld
Seam Seal
Squared corner and dot on
top of case indicate pin one.
0.805 max. (20.45)
0.697 (17.70)
1
2
3
4
0.018 0.002 dia.
(0.46 0.05)
7
6
5
0.097 (2.46)
0.000
Seal hole: 0.056 0.002 (1.42 0.05)
Case dimensions in inches (mm)
Tolerance 0.005 (0.13) for three decimal places
0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin
Materials
Header
Cover
Pins
Kovar/Nickel/Gold
Kovar/Nickel
Kovar/Nickel/Gold matched glass seal
Case A2, Rev C, 20060110
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
FIGURE 33: CASE A2
www.craneae.com
Page 15 of 18
Rev E - 20060508