DC/DC C
onverters
BOTTOM VIEW CASE H6
hr150 SerieS
20 Watt
Solder Seal
1.120 max (28.45)
Dot on top of case indicates pin one
0.960 (24.38)
1
2
3
4
5
0.040 dia
(1.02)
Solder Tip-off
0.160 (4.06)
0.000
0.000
0.495 max (12.57)
10
9
8
7
6
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage the device.
Solder pins individually with heat application not exceeding 300°C for 10 seconds per pin.
Materials
Header
Cold Rolled Steel/Nickel/Tin
Cover
Cold Rolled Steel/Nickel/Tin
Pins
#52 alloy, compression glass seal or ceramic seal
Case H6, Rev C, 20060802
Please refer to the numerical dimensions for accuracy. All information is believed to be accurate,
but no responsibility is assumed for errors or omissions. Interpoint reserves the right to make
changes in products or specifications without notice.
Copyright © 1999-2006 Interpoint Corp. All rights reserved.
f
igURe
4: c
aSe
H6 – HR151
anD
HR152
2.110 max (53.59)
0.255 (6.48)
0.655 (16.64)
1.055 (26.80)
1.455 (36.96)
0.25 +0.05/-0.00
(6.4 +1.3/-0.0)
1.855 (47.12)
0.000
6
CRANE [ Crane Aerospace & Electronics. ]
