Digitally Controlled Analog I/O Processor
17
MX839 PRELIMINARY INFORMATION
Operating Characteristics Notes:
1. Measured over a 0 to 30kHz Band.
2. The extremes of the DAC output range (when resistively loaded) is affected by the output impedance of the DAC
buffer. Under these conditions, the output impedance can approach 200:. However; when the output is operating
well within the supply; the output impedance will be significantly lower, thereby improving the loaded performance.
3. R
= 5k: AV
= 5.0V.
LOAD
DD
4. Loads less than 1k: will produce output distortion.
5. Small signal impedance, at AV = 5V and T = 25°C.
DD
AMB
6. Differential non-linearity is defined as the difference in width between adjacent code midpoints and the width of an
ideal LSB, divided by the width of an ideal LSB. See Figure 3.
7. Integral non-linearity is defined as the width difference between an actual code midpoint and the line of best fit
through all code midpoints, divided by the width of an ideal LSB. See Figure 4.
8. 6MHz operation at V = 5.0V only. The ‘C-BUS’ clock must be at lest 4 times slower than the XTAL/CLOCK
DD
frequency.
Analog
Output
To
AVDD
Code Width=2LSBs
Ideal
Differential Non-Linearity=1LSB
Response
Actual Response
Digital
Input
0V
000$
To $2FF
Figure 3: Differential Non-Linearity of a D/A Converter
Analog
Output
768/768
704/768
640/768
576/768
512/768
448/768
384/768
320/768
256/768
192/768
128/768
64/768
Actual Response
Ideal
Response
5 LSBs
0/768
Digital
Input
000 040 080 0C0 100 140 180 1C0 200 240 280 2FF
Figure 4: Integral Non-Linearity of a D/A Converter
© 1998 MXxCOM Inc.
www.mxcom.com Tele: 800 638-5577 336 744-5050 Fax: 336 744-5054
Doc. # 20480164.002
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA
All trademarks and service marks are held by their respective companies.
CMLMICRO [ CML MICROCIRCUITS ]
