Pin Number
FX619 FX619 FX619
J
L1/L2 M1
1
1
1
Function
Xtal/Clock :
Input to the clock oscillator inverter. A 1.024MHz Xtal input or externally
derived clock is injected here. See Clock Mode pins and Figure 3.
2
2
No connection
2
3
3
Xtal :
Output of clock oscillator inverter. Xtal circuitry shown is in accordance with CML
application note D/XT/1 April 1986.
3
4
4
No connection
4
5
5
Encoder Data Clock :
A logic I/O port. External encode clock input or internal data clock
output. Clock frequency is dependant upon clock mode 1, 2 inputs and Xtal frequency (see
Clock Mode pins).
5
6
6
Encoder Output :
The encoder digital output, this is a three state output whose condition is
set by Data Enable and Powersave inputs as shown :
Data Enable
1
0
1
Powersave
1
1
0
Encoder Output
Enabled
High Z (o/c)
Vss
7, 8
No connection
6
7
9
Encoder Force Idle :
When this pin is a logical '0' the encoder is forced to an idle state and
the encoder digital output is 0101..., a perfect idle pattern. When this pin is a logical '1' the
encoder encodes as normal. Internal 1MΩ Pullup.
7
8
10
Data Enable :
Data is made available at the encoder output pin by control of this input. See
Encoder Output pin. Internal 1MΩ Pullup.
8
9
11
No connection
9
10
12
Bias :
Normally at V
DD
/2 bias, this pin requires to be externally decoupled by a capacitor,
C
4
. Internally pulled to V
SS
when "Powersave" is a logical '0'.
10
11
13
Encoder Input :
The analogue signal input. Internally biased at V
DD
/2, external
components are required on this input. The source impedance should be less than 100Ω,
output idle channel noise levels will improve with an even lower source impedance. See
Fig. 3.
V
SS
:
Negative Supply.
2
11
12
14
CMLMICRO [ CML MICROCIRCUITS ]
