CS3511
Parameters
General Specifications
Efficiency
Symbol
Test Conditions
Min
Typ
Max Units
PO = 2 x 9.4 W, RL = 8 Ω
-
-
86
-
-
%
%
η
Gain Matching
Between output channels
0.1
Power Supply Rejection Ratio
200 mv p-p from
20 Hz ≤ f ≤ 1 kHz, inputs AC
coupled to AGND
-
55
-
dB
PSRR
IHF Intermodulation Distortion
Input Impedance
19 kHz, 20 kHz, 1:1 (IHF),
PO = 1 W
IHF-IMD
-
0.20
-
%
(Note 9)
Gain1 = 0, Gain0 = 0
Gain1 = 0, Gain0 = 1
Gain1 = 1, Gain0 = 0
Gain1 = 1, Gain0 = 1
36.8
18.4
11.0
7.3
-
46.0
23.0
13.8
9.2
55.2
27.6
16.6
11.1
-
kΩ
kΩ
kΩ
kΩ
mV
A
Output Offset Voltage
(Note 10) VOFFSET MUTE = low
50
PWM Output Over-Current Error Trigger Point
Junction Thermal Error Rising Trigger Point
Junction Thermal Error Falling Trigger Point
Turn On Time
ICE
TTERISE
TTEFALL
ton
-
2.7
-
-
-
-
-
155
135
155
3
-
-
-
-
°C
°C
SLEEP = VIL
SLEEP = VIH
ms
ms
Turn Off Time
toff
Notes:
5. All audio input signals supplied differentially to the CS3511.
6. See Figure 5 on page 18.
7. dBi is referenced to the input signal amplitude resulting in the specified output power at THD+N<1%. See
“Parameter Definitions” on page 22 for more information.
8. All audio input signals supplied single ended to the CS3511 with the negative input terminated to GND
through an impedance matching circuit as described in Section 4.1 on page 13.
9. Input impedance is measured between the positive (INx+) and negative (INx-) input pins of the CS3511.
10. See Section 4.2 “Dynamic DC Offset Calibration” on page 13.
8
DS845F1