CS2300-OTP
5.6
Auxiliary Output
The auxiliary output pin (AUX_OUT) can be mapped, as shown in Figure 12, to one of three signals: input
clock (CLK_IN), additional PLL clock output (CLK_OUT), or a PLL lock indicator (Lock). The mux is con-
trolled via the AuxOutSrc[1:0] modal parameter. If AUX_OUT is set to Lock, the AuxLockCfg global param-
eter is then used to control the output driver type and polarity of the LOCK signal (see section 6.3.1 on
page 20). If AUX_OUT is set to CLK_OUT, the phase of the PLL Clock Output signal on AUX_OUT may
differ from the CLK_OUT pin. The driver for the pin can be set to high-impedance using the M2 pin when
the M2Config[1:0] global parameter is set to either 001 or 010.
AuxOutSrc[1:0]
M2 pin with
M2Config[1:0] = 001, 010
Frequency Reference Clock
(CLK_IN)
Auxiliary Output Pin
(AUX_OUT)
PLL Clock Output
(PLLClkOut)
3:1 Mux
PLL Lock/Unlock Indication
(Lock)
AuxLockCfg
Figure 12. Auxiliary Output Selection
Referenced Control
Parameter Definition
AuxOutSrc[1:0]......................“Auxiliary Output Source Selection (AuxOutSrc[1:0])” on page 20
AuxOutDis.............................“M2 Configured as Output Disable” on page 17
AuxLockCfg...........................“AUX PLL Lock Output Configuration (AuxLockCfg)” section on page 20
M2Config[2:0]........................“M2 Pin Configuration (M2Config[2:0])” on page 21
5.7
Mode Pin Functionality
5.7.1
M1 and M0 Mode Pin Functionality
M[1:0] determine the functional mode of the device and select both the default User Defined Ratio and
the set of modal parameters. The modal parameters are RModSel[1:0], and AuxOutSrc[1:0]. By modifying
one or more of the modal parameters between the 4 sets, different functional configurations can be
achieved. However, global parameters are fixed and the same value will be applied to each functional
configuration. Figure 14 on page 19 provides a summary of all parameters used by the device.
16
DS844F1
CIRRUS [ CIRRUS LOGIC ]
