CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Radial Lead
@Super
low ESR, high temperature resistance
@Large
capacitance & Improved high ripple current capability
@Rated
voltage range : 2.5 to 25V
dc
@2000
hours at 105C
@Suitable
for DC-DC converters, voltage regulators and decoupling applications
For computer motherboards
@Pb-free
design
?SPECIFICATIONS
Items
Category
Temperature Range
Rated Voltage Range
Capacitance Tolerance
Surge Voltage
Leakage Current
*Note
Dissipation Factor
(tane)
Low Temperature
Characteristics
Endurance
-55 to +105C
2.5 to 25V
dc
P20%
(M)
Rated voltageB1.15V
I=0.2CV (max.)
Where, I : Leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (V
dc
)
0.12 max.
Characteristics
(at 20C, 120Hz)
(at 105C)
(at 20C after 2 minutes)
(at 20C, 120Hz)
Bias Humidity Test
Surge Voltage Test
Failure Rate
Max. impedance ratio at 100kHz to the 20C value
Z(-25C)/Z(+20C)[1.15
Z(-55C)/Z(+20C)[1.25
The following specifications shall be satisfied when the capacitors are restored to 20C after the rated voltage is applied for 2000 hours
at 105C.
Appearance
No significant damage
Capacitance change
[P20%
of the initial measured value
D.F. (tanE)
[150%
of the initial specified value
ESR
[150%
of the initial specified value
Leakage current
[The
initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20C after subjecting them to DC voltage at 60C,
90 to 95% RH for 500 hours.
Appearance
No significant damage
Capacitance change
[P20%
of the initial measured value
D.F. (tanE)
[150%
of the initial specified value
ESR
[150%
of the initial specified value
Leakage current
[The
initial specified value
The capacitors shall be subjected to 1000 cycles each consisting of charge with the surge voltage specified at 105C for 30 seconds
through a protective resistor(R=1kO) and discharge for 5 minutes 30 seconds.
Appearance
No significant damage
Capacitance change
[P20%
of the initial measured value
D.F. (tanE)
[150%
of the initial specified value
ESR
[150%
of the initial specified value
Leakage current
[The
initial specified value
1% per 1000 hours maximum (Confidence level 60% at 105C)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105C.
?DIMENSIONS
[mm]
@Terminal
Code : E
F0.6
Coated Case
FD+0.5max.
FP0.5
?MARKING
EX) 4V820MF
PS
18M
820
4
V
fD
L
F
8
11.5
3.5
10
12.5
5.0
L+1.5 max.
15min.
4min.
(1/2)
CAT. No. E1001E
CHEMI-CON [ UNITED CHEMI-CON, INC. ]
