+PC2709TB
NOTES ON CORRECT USE
(1) Observe precautions for handling because of electro-static sensitive devices.
(2) Form a ground pattern as widely as possible to minimize ground impedance (to prevent undesired oscillation).
All the ground pins must be connected together with wide ground pattern to decrease impedance difference.
(3) The bypass capacitor should be attached to the VCC pin.
(4) The inductor (L) must be attached between VCC and output pins. The inductance value should be determined in
accordance with desired frequency.
(5) The DC cut capacitor must be attached to input and output pin.
RECOMMENDED SOLDERING CONDITIONS
This product should be soldered under the following recommended conditions. For soldering methods and condi-
tions other than those recommended below, contact your NEC sales representative.
Soldering Method
Infrared Reflow
Soldering Conditions
Recommended Condition Symbol
IR35-00-3
Package peak temperature: 235°C or below
Time: 30 seconds or less (at 210°C)
Count: 3, Exposure limit: NoneNote
VPS
Package peak temperature: 215°C or below
Time: 40 seconds or less (at 200°C)
Count: 3, Exposure limit: NoneNote
VP15-00-3
WS60-00-1
–
Wave Soldering
Partial Heating
Soldering bath temperature: 260°C or below
Time: 10 seconds or less
Count: 1, Exposure limit: NoneNote
Pin temperature: 300°C
Time: 3 seconds or less (per side of device)
Exposure limit: NoneNote
Note After opening the dry pack, keep it in a place below 25°C and 65% RH for the allowable storage period.
Caution Do not use different soldering methods together (except for partial heating).
For details of recommended soldering conditions for surface mounting, refer to information document
SEMICONDUCTOR DEVICE MOUNTING TECHNOLOGY MANUAL (C10535E).
13
Data Sheet P12653EJ3V0DS00
CELDUC [ celduc-relais ]
