MC-7831-HA
ELECTRICAL CHARACTERISTICS (TA = 30±5 °C, VDD = 24 V, ZS = ZL = 75 Ω)
IDD
Operating Current
mA
dBc
dBc
dBc
180
–
–
–
–
240
-57
-50
-57
RF OFF
f = 40 to 870 MHz; 110 Channels,
OUT = 44 dBmV, Flat
CTB
Composite Triple Beat
Cross Modulation
–
V
XMod
CSO
–
Composite Second Order
–
RECOMMENDED
OPERATING CONDITIONS (Zs = ZL = 75Ω)
ABSOLUTE
MAXIMUM RATINGS1 (TCASE= 30 °C)
SYMBOLS
PARAMETERS
UNITS
RATINGS
30
SYMBOLS
PARAMETERS
UNITS MIN TYP MAX
VDD
VI
Supply Voltage
V
VDD
Supply Voltage
MC-7831-HA
V
23.5 24.0 24.5
Input Voltage2
dBmV
°C
65
Vi
Input Voltage1
MC-7831-HA
dBmV
TC
Operating Case Temperature
Storage Temperature
-30 to +100
-40 to +100
–
21.0 27.5
TSTG
°C
TC
Operating Case
Temperature
MC-7831-HA
°C
Note:
1. Operation in excess of any one of these parameters may result in
permanent damage.
2. Maximum single channel power applied to the input for 1 minute
with no measurable degradation in performance.
-30 +25 +85
Note:
1. Test Conditions: 110 Channels, Flat
ORDERING INFORMATION
PART NUMBER
PACKAGE
QUANTITY
MC-7831-HA-AZ 7-pin special with heatsink 25 pcs max/ Tray
(Pb-Free )
RECOMMENDED SOLDERING CONDITIONS
NOTES ON CORRECT USE
This product should be soldered in the following recommended
conditions. Other soldering methods and conditions than the recom-
mended conditions are to be consulted with our sales representa-
tives.
1. The space between PC board and root of the lead should be kept
more than 1 mm to prevent undesired stress on the lead and also
should be kept less than 4 mm to prevent undesired parasitic
inductance.
Soldering
Method
Soldering
Conditions
Condition
Symbol
Recommended space is 2.0 to 3.0 mm typical.
2. Recommended torque strength of the screw is 59 to 78 Ncm.
Pin Part Heating Pin area temperature: less
than 260°C1
–
3. Form the ground pattern as wide as possible to minimize ground
impedance. (to prevent undesired oscillation)
Hour: Within 2 sec./pin
All the ground pins must be connected together with wide ground
Note.
pattern to decrease impedance difference.
1. The point of pin part heating must be kept at a distance of more
than 1.2 mm from the root of lead.
The information in this document is subject to change without notice. Before using this document, please confirm
that this is the latest version.
Life Support Applications
hese NEC products are not intended for use in life support devices, appliances, or systems where the malfunction of these prod
T
ucts can reasonably
be expected to result in personal injury. The customers of CEL using or selling these products for use in such applications do
agree to fully indemnify CEL for all damages resulting from such improper use or sale.
so at their own risk and
CEL [ CALIFORNIA EASTERN LABS ]
