Mechanical Outline
TOLERANCES
+.008” for 3 place decimals
+ .02” for 2 place decimals
+ .002” for pin diameter
Pin Out
Pin
1
2
3
4
5
6
7
8
9
Function
V
o
V
o
TRIM
GND
INTI
Gnd
INT2
V
i
V
i
Description
Output Voltage
Output Voltage
Output Adjust*
Ground
InterModule 1
Ground
InterModule 2
5V Input Voltage
5V Input Voltage
System Interconnection Guidelines
1. Each SIP must have input, ground and output pins
sunk into common input ground and output planes in
the host PC board.
2. Two additional common signal traces are required to
interconnect INT1 and INT2 pins. These traces must
be a least 0.06” wide and make a straight connection
among the modules.
3. Power Booster SIP must be adjacent to the Control
SIP located in the center of the layout, as shown in
the Typical Example figure. Recommended distance
between SIP pin centers is 0.5”.
4. A 300 LFM air flow is required in direction from Pin 9 to
Pin 1, to draw rated power from booster configuration.
Each application using boosters should be evaluated
for thermal performance.
* not connected on Boosters
Standard Options are shown, consult factory for other available options.
C&D Technologies (Power Electronics) Ltd.
Shannon, Co. Clare, Ireland
Tel: +353.61.474.133 Fax:+353.61.474.141
Power Electronics Division, United States
3400 E Britannia Drive, Tucson, Arizona 85706
Tel: 800.547.2537 Fax: 520.770.9369
C&D Technologies, (NCL)
Milton Keynes MK14 5BU UK
Tel: +44 (0)1908 615232 Fax: +44 (0)1908 617545
Any data, prices, descriptions or specifications presented herein are subject to revision by C&D Technologies, Inc. without notice. While such information is believed to
be accurate as indicated herein, C&D Technologies, Inc. makes no warranty and hereby disclaims all warranties, express or implied, with regard to the accuracy or
completeness of such information. Further, because the product(s) featured herein may be used under conditions beyond its control, C&D Technologies, Inc. hereby
disclaims all warranties, either express or implied, concerning the fitness or suitability of such product(s) for any particular use or in any specific application or arising from
any course of dealing or usage of trade. The user is solely responsible for determining the suitability of the product(s) featured herein for user’s intended purpose and
in user’s specific application. C&D Technologies, Inc. does not warrant or recommend that any of its products be used in any life support or aviation or aerospace
applications.
Page 4
6-PAK
8/2001
REV F
CANDD [ C&D TECHNOLOGIES ]
