Chapter 3
Hardware Installation
This chapter provides the information on how to install the hardware
using the HS-4701.
3.1 Before Installation
After confirming your package contents, you are now ready to install
your hardware. The following are important reminders and steps to
take before you begin with your installation process.
1.
Make sure that all jumper settings match their default settings
and CMOS setup correctly. Refer to the sections on this chapter
for the default settings of each jumper.
2.
Go through the connections of all external devices and make
sure that they are installed properly and configured correctly
within the CMOS setup. Refer to the sections on this chapter
for the detailed information on the connectors.
3.
4.
Keep the manual and diskette in good condition for future
reference and use.
Make sure your power supply is using for P4 only. One of 4-pin
connector is for +12V lead which should connect to PW2 and
20-pin ATX connector to PW1.
7
BOSER [ BOSER TECHNOLOGY CO., LTD ]
