ADC
AS1419
AS1419A
Austin Semiconductor, Inc.
NOTES:
1. Absolute Maximum Ratings are those values beyond which
the life of a device may be impaired.
2.All voltage values are with respect to ground with DGND and
AGND wired together unless otherwise noted.
7. Integral nonlinearity is defined as the deviation of a code
from a straight line passing through the actual endpoints of the
transfer curve. The deviation is measured from the center of
the quantization band.
8. Bipolar offset is the offset voltage measured from –0.5LSB
when the output code flickers between 0000 0000 0000 00 and
1111 1111 1111 11.
9. Guaranteed by design, not subject to test.
10. Recommended operating conditions.
11. The falling edge of CONVST\ starts a conversion. If
CONVST\ returns high at a critical point during the conversion
it can create small errors. For best performance ensure that
CONVST\ returns high either within 650ns after the start of the
conversion or after BUSY\ rises.
3. When these pin voltages are taken below VSS or above VDD
,
they will be clamped by internal diodes. This product can handle
input currents greater than 100mA below VSS or above VDD
without latchup.
4. When these pin voltages are taken below VSS, they will be
clamped by internal diodes. This product can handle input
currents greater than 100mA below VSS without latchup. These
pins are not clamped to VDD
.
5. VDD = 5V, VSS = –5V, fSAMPLE = 800kHz, tr = tf = 5ns unless
otherwise specified.
6. Linearity, offset and full-scale specifications apply for a single
ended +AIN input with – AIN grounded.
FUNCTIONAL BLOCK DIAGRAM
Austin Semiconductor, Inc. reserves the right to change products or specifications without notice.
AS1419 & AS1419A
Rev. 1.5 08/09
5
AUSTIN [ AUSTIN SEMICONDUCTOR ]
