Voltage
Comparator
AS111 RAD-TOL
PRELIMINARY SPECIFICATION
Austin Semiconductor, Inc.
ABSOLUTE MAXIMUM RATINGS*,5
*Stresses greater than those listed under "Absolute Maximum
Ratings" may cause permanent damage to the device. This is
a stress rating only and functional operation of the device at
these or any other conditions above those indicated in the
operation section of this specification is not implied. Exposure
to absolute maximum rating conditions for extended periods
may affect reliability.
Operating Temperature Range ....................... -55C < Ta < +125C
Maximum JunctionTemperature ......................................... +175C
Storage Temperature Range ........................... -65C <Ta < +150C
Lead Temperature (soldering for 60 sec) ............................ 300C
Total SupplyVoltage (V84).............................................................36V
Output to Negative SupplyVoltage (V74)....................................50V
Ground to Negative SupplyVoltage (V14)...................................30V
Differential InputVoltage.............................................................±30V
InputVoltage4................................................................................±15V
Output Short Circuit Duration..................................................10 sec
LeadTemperature (Soldering, 10 sec).......................................260°C
Voltage at Stobe Pin..............................................................V+ -5V
Maximum Strobe Current ..................................................... 10mA
Sink Current ...........................................................................50mA
Package Weight:
10 Lead Cerpack Flatpak ................................... 240mg
10 Lead Cerpack Gullwing ................................ 220mg
8 Lead Metal Can ............................................... 950mg
8 Lead Cerdip ..................................................... 1100mg
Note 4: This rating applies for ±15 supplies. The positive input voltage limit is 30V above the negative supply. The negative input voltage
limit is equal to the negative supply voltage or 30V below the positive supply, whichever is less.
Note 5: The maximum junction temperature of the AS111 is 175°C. For operating at elevated temperatures, devices in the TO08 package
must be derated based on a thermal resistance of 160°C/W, junction to ambient, or 50°C/W, junction to case. The thermal resistance of the
C008 dual-in-line package is 130°C/W, junction to ambient, and 20°C/W Junction to Case. The thermal resistance of the CP10 Cerpack
Flatpak & the GW10 Cerpack Gullwing are 230°C/W for juntion to ambient and 25°C/W Junction to Case.
These figures are based on Still Air
& 1/2 Watt power dissipation.
(The following Table applies to the Subgroup column in the Electrical Characteristics Tables)
SUBGROUP
Description
TEMP(OC)
+25
1
2
3
4
5
6
7
8
9
Static DC tests
Static DC tests
Static DC tests
Dynamic Tests
Dynamic Tests
Dynamic Tests
Functional Tests
Functional Tests
Functional Tests
+125
-55
+25
+125
-55
+25
+125
-55
AS111 RAD-TOL
Rev. 1.1 06/05
AustinSemiconductor,Inc.reservestherighttochangeproductsorspecificationswithoutnotice.
4
AUSTIN [ AUSTIN SEMICONDUCTOR ]
