Austin Semiconductor, Inc.
TYPICAL APPLICATIONS (CONTINUED)
3
oltag
Volta g e
Comparator
AS111
NOTE:
Do Not Ground Strobe Pin
NOTE 2:
Typical input current is 50pV with inputs strobed off.
NOTE 3:
Pin connections shown on schematic diagram and typical applications are for TO08 metal can package.
ABSOLUTE MAXIMUM RATINGS*
,5
Total Supply Voltage (V
84
).............................................................36V
Output to Negative Supply Voltage (V
74
)....................................50V
Ground to Negative Supply Voltage (V
14
)...................................30V
Differential Input Voltage.............................................................±30V
Input Voltage
4
................................................................................±15V
Output Short Circuit Duration..................................................10 sec
Lead Temperature (Soldering, 10 sec).......................................260°C
Voltage at Stobe Pin................................................................V
+
-5V
*Stresses greater than those listed under "Absolute Maximum
Ratings" may cause permanent damage to the device. This is
a stress rating only and functional operation of the device at
these or any other conditions above those indicated in the
operation section of this specification is not implied. Exposure
to absolute maximum rating conditions for extended periods
may affect reliability.
Note 4:
This rating applies for ±15 supplies. The positive input voltage limit is 30V above the negative supply. The negative input voltage limit
is equal to the negative supply voltage or 30V below the positive supply, whichever is less.
Note 5:
The maximum junction temperature of the AS111 is 150°C. For operating at elevated temperatures, devices in the TO08 package must
be derated based on a thermal resistance of 165°C/W, junction to ambient, or 20°C/W, junction to case. The thermal resistance of the dual-in-line
package is 110°C/W, junction to ambient.
AS111
Rev. 1.6 6/05
Austin Semiconductor, Inc. reserves the right to change products or specifications without notice.
3