ATmega48/88/168
TA = -40°C to 85°C, VCC = 1.8V to 5.5V (unless otherwise noted) (Continued)
Symbol
Parameter
Condition
Min.
Typ.
Max.
Units
Active 1MHz, VCC = 2V
(ATmega48/88/168V)
0.55
mA
Active 4MHz, VCC = 3V
(ATmega48/88/168L)
3.5
12
mA
mA
mA
mA
mA
Active 8MHz, VCC = 5V
(ATmega48/88/168)
Power Supply Current(5)
Idle 1MHz, VCC = 2V
(ATmega48/88/168V)
0.25
0.5
1.5
5.5
ICC
Idle 4MHz, VCC = 3V
(ATmega48/88/168L)
Idle 8MHz, VCC = 5V
(ATmega48/88/168)
WDT enabled, VCC = 3V
WDT disabled, VCC = 3V
8
1
15
2
µA
µA
Power-down mode
VCC = 5V
Analog Comparator
Input Offset Voltage
VACIO
IACLK
tACID
10
40
50
mV
nA
ns
Vin = VCC/2
Analog Comparator
Input Leakage Current
VCC = 5V
Vin = VCC/2
-50
Analog Comparator
Propagation Delay
VCC = 2.7V
VCC = 4.0V
750
500
Notes: 1. “Max” means the highest value where the pin is guaranteed to be read as low
2. “Min” means the lowest value where the pin is guaranteed to be read as high
3. Although each I/O port can sink more than the test conditions (20 mA at VCC = 5V, 10 mA at VCC = 3V) under steady state
conditions (non-transient), the following must be observed:
ATmega48/88/168:
1] The sum of all IOL, for ports C0 - C5, ADC7, ADC6 should not exceed 100 mA.
2] The sum of all IOL, for ports B0 - B5, D5 - D7, XTAL1, XTAL2 should not exceed 100 mA.
3] The sum of all IOL, for ports D0 - D4, RESET should not exceed 100 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
4. Although each I/O port can source more than the test conditions (20 mA at VCC = 5V, 10 mA at VCC = 3V) under steady state
conditions (non-transient), the following must be observed:
ATmega48/88/168:
1] The sum of all IOH, for ports C0 - C5, D0- D4, ADC7, RESET should not exceed 150 mA.
2] The sum of all IOH, for ports B0 - B5, D5 - D7, ADC6, XTAL1, XTAL2 should not exceed 150 mA.
If IIOH exceeds the test condition, VOH may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
5. Values with “Minimizing Power Consumption” enabled (0xFF).
305
2545M–AVR–09/07
ATMEL [ ATMEL ]
