ATmega48/88/168
Errata ATmega88
Rev. A
The revision letter in this section refers to the revision of the ATmega88 device.
• Writing to EEPROM does not work at low Operating Voltages
• Part may hang in reset
1. Writing to EEPROM does not work at low operating voltages
Writing to the EEPROM does not work at low voltages.
Problem Fix/Workaround
Do not write the EEPROM at voltages below 4.5 Volts.
This will be corrected in rev. B.
2. Part may hang in reset
Some parts may get stuck in a reset state when a reset signal is applied when the
internal reset state-machine is in a specific state. The internal reset state-machine is
in this state for approximately 10 ns immediately before the part wakes up after a
reset, and in a 10 ns window when altering the system clock prescaler. The problem
is most often seen during In-System Programming of the device. There are theoreti-
cal possibilities of this happening also in run-mode. The following three cases can
trigger the device to get stuck in a reset-state:
- Two succeeding resets are applied where the second reset occurs in the 10ns win-
dow before the device is out of the reset-state caused by the first reset.
- A reset is applied in a 10 ns window while the system clock prescaler value is
updated by software.
- Leaving SPI-programming mode generates an internal reset signal that can trigger
this case.
The two first cases can occur during normal operating mode, while the last case
occurs only during programming of the device.
Problem Fix/Workaround
The first case can be avoided during run-mode by ensuring that only one reset
source is active. If an external reset push button is used, the reset start-up time
should be selected such that the reset line is fully debounced during the start-up
time.
The second case can be avoided by not using the system clock prescaler.
The third case occurs during In-System programming only. It is most frequently
seen when using the internal RC at maximum frequency.
If the device gets stuck in the reset-state, turn power off, then on again to get the
device out of this state.
339
2545D–AVR–07/04
ATMEL [ ATMEL ]
