ATmega16U4/ATmega32U4
2.2.11
UVCC
USB Pads Internal Regulator Input supply voltage.
2.2.12
UCAP
USB Pads Internal Regulator Output supply voltage. Should be connected to an external capac-
itor (1µF).
2.2.13
VBUS
USB VBUS monitor input.
2.2.14
RESET
Reset input. A low level on this pin for longer than the minimum pulse length will generate a
reset, even if the clock is not running. The minimum pulse length is given in
Shorter pulses are not guaranteed to generate a reset.
2.2.15
XTAL1
Input to the inverting Oscillator amplifier and input to the internal clock operating circuit.
2.2.16
XTAL2
Output from the inverting Oscillator amplifier.
2.2.17
AVCC
AVCC is the supply voltage pin (input) for all the A/D Converter channels. If the ADC is not used,
it should be externally connected to V
CC
. If the ADC is used, it should be connected to V
CC
through a low-pass filter.
2.2.18
AREF
This is the analog reference pin (input) for the A/D Converter.
3. About Code Examples
This documentation contains simple code examples that briefly show how to use various parts of
the device. Be aware that not all C compiler vendors include bit definitions in the header files
and interrupt handling in C is compiler dependent. Please confirm with the C compiler documen-
tation for more details.
These code examples assume that the part specific header file is included before compilation.
For I/O registers located in extended I/O map, "IN", "OUT", "SBIS", "SBIC", "CBI", and "SBI"
instructions must be replaced with instructions that allow access to extended I/O. Typically
"LDS" and "STS" combined with "SBRS", "SBRC", "SBR", and "CBR".
7
7766BS–AVR–07/08