AT85C51SND3Bx
Signals Description
System
Table 1.
System Signal Description
Signal
Name
Type
Description
Reset Input
Holding this pin low for 64 oscillator periods while the oscillator is
running resets the device. The Port pins are driven to their reset
conditions when a voltage lower than V
IL
is applied, whether or not the
oscillator is running.
This pin has an internal pull-up resistor (R
RST
) which allows the device
to be reset by connecting a capacitor between this pin and V
SS
.
Asserting RST when the chip is in Idle mode or Power-Down mode
returns the chip to normal operation.
In order to reset external components connected to the RST line a low
level 96-clock period pulse is generated when the watchdog timer
reaches its time-out period.
In System Programming
Assert this pin during reset phase to enter the in system programming
mode.
Alternate
Function
RST
I/O
-
ISP
I
OCDT
Table 2.
Ports Signal Description
Signal
Name
P0.7:0
Type
I/O
Description
Port 0
P0 is an 8-bit bidirectional I/O port with internal pull-ups.
Port 1
P1 is an 8-bit bidirectional I/O port with internal pull-ups.
Alternate
Function
LD7:0
P1.7:0
I/O
KIN3:0
SDINS
SDLCK
SDCMD
SDCLK
SDDAT3:0
RXD
MISO
TXD
MOSI
INT0
RTS
SCK
INT1
CTS
SS
T0
UVCON
UID
P2.7:0
I/O
Port 2
P2 is an 8-bit bidirectional I/O port with internal pull-ups.
P3.4:0
P3.7:6
I/O
Port 3
P3 is a 7-bit bidirectional I/O port with internal pull-ups.
7
7632A–MP3–03/06
ATMEL [ ATMEL CORPORATION ]
