M67204H
Pin Description
Names
FF
XO/HF
XI
FL/RT
VCC
GND
I0-8
Q0-8
W
R
RS
EF
Description
Full Flag
Expansion Out/Half-Full Flag
Expansion IN
First Load/Retransmit
Power Supply
Ground
Inputs
Outputs
Write Enable
Read Enable
Reset
Empty Flag
Data In (I
0
- I
8
)
Reset (RS)
Data inputs for 9-bit data
Reset occurs whenever the Reset (RS) input is taken to a low state. Reset returns both
internal read and write pointers to the first location. A reset is required after power-up
before a write operation can be enabled. Both the Read Enable (R) and Write Enable
(W) inputs must be in the high state during the period shown in Figure 1 (i.e. t
RSS
before
the rising edge of RS) and should not change until t
RSR
after the rising edge of RS. The
Half-Full Flag (HF) will be reset to high After Reset (RS).
Figure 1.
Reset
Notes:
1. EF, FF and HF may change status during reset, but flags will be valid at t
RSC
.
2. W and R = VIH around the rising edge of RS.
3
4141J–AERO–04/07