2. Standard Conformity
The cameras have been tested in the following conditions:
• Camera with complete Atmel housing
• Shielded power supply cable
• Camera Link data transfer cable ref. 14B26-SZLB-500-OLC (3M™)
• Linear AC-DC power supply
Atmel recommends using the same configuration to ensure compliance with the following
standards.
2.1
2.2
CE Conformity
The ATMOS cameras comply with the European directive 89/336/CEE (EN55022 A/CISPR22 A,
EN55024, EN61000-6-2).
FCC conformity
ATMOS Cameras comply with Part 15 of FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
4
ATMOS -2M60/2M30 [Preliminary]
5440A–IMAGE–10/05
ATMEL [ ATMEL ]
