12W Medical Grade Wallmount Switching Power Adapters
AMP1201 series
PHYSICAL SPECIFICATIONS
INPUT SPECIFICATIONS
Size
2.56” x 2.17” x 1.40”
(65x55x35.6mm)
Wallmount Style
5.64oz (160g)
Input Voltage Range
Frequency Range
Input Current
80-275 VAC (100-240V Nominal)
47-63 Hz
Construction
Weight
Low Line (100VAC)
0.29A max.
High Line (240VAC)
0.16A max.
50A max.
Inrush Current, typ (Cold Start) Low Line (100VAC)
High Line (230VAC)
100A max.
ENVIRONMENTAL SPECIFICATIONS
Leakage Current
<100 uA
Oper. Temperature
-10 to +50°C (FL) *
Protection Class
Double Insulated, Class II
50% Load @ 70°C
No Load Power Consumption
0.3W
(See Derate Curve Next Page)
Free Air Convection
Cooling
OUTPUT SPECIFICATIONS
Flammability Rating
Storage Temperature
Operating/Storage Humidity
EMC
UL94V-1
-40 to +85°C (10-95% RH) *
0% to 95%, non-cond *
Compliance to EN55011 (CISPR11),
EN61000-3-2,-3 Class B
Voltage and Current
See Selection Chart
0 to FL Rating
± 1%, max.
Output Power Range
Line Regulation (FL) (Note 1)
Over Voltage Protection
Over Load Protection
Transient Response
112-132%
MTBF (MIL-HDBK-217F, 25 °C) 100,000 Hrs min.
110-150% Auto-Recovery
110Vin, FL
Efficiency Level
V
4mS
Surge Voltage
2kV min.
Temperature Coefficient
Ripple/Noise (Note 3)
Short Circuit Protection
Start Up / Hold Up Time
±0.04%/°C, typ
ESD
Air:
IEC61000-4-2, 8kV min.
IEC61000-4-2, 6kV min.
3000M max.
FL, 90Vin
1% Pk-Pk max.
Contact:
Continuous, self-recovering *
100Vin, FL
Operating Altitude
2S max. / 16mS min.
Vibration
10 ~ 500Hz, 10min./1cycle, 60min.
each along X, Y, Z axes, 5G min
GENERAL SPECIFICATIONS
NOTES
Input-Out Isolation
Efficiency(FL, Nom. Vin)
Safety
4000 VAC
See Selection Chart
1. Line Regulation defined as changing the input voltage ±10% from
nominal line at rated load.
ANSI/AAMI ES 60601-1:2005
(UL/cUL/EN/IEC 3rd Edition)
2. Total Regulation is defined by as changing the load ±40% from 60%
rated load.
3. Ripple & Noise is measured by using a 20MHz bandwidth limited
oscilloscope and terminating the output with a 0.47uF capacitor at
rated load and nominal line.
All specifications are typical at nominal input, full load, and 25°C unless other-
wise noted
* These are stress ratings. Exposure of the devices to any of these conditions
may adversely affect long term reliability. Proper operation under conditions
other than the standard operating conditions is neither warranteed nor implied.
ASTRODYNE USA: 1-800-823-8082
ASTRODYNE PACIFIC: 886-2-26983458
WWW.ASTRODYNETDI.COM
ASTRODYNE [ ASTRODYNE CORPORATION ]
