APA06 Non-Isolated Power SIPs
3V-5.5V Input, 1.2V-3.3V Output, 9-20W Output
output also grounded.
Mechanical Considerations
3. Any non-SELV input must be provided with
reinforced from any other hazardous voltages,
including the ac mains, and must have a SELV
reliability test performed on it in combination
with the converters. Inputs must meet SELV
requirements.
Thermal Performance
APA06 series will derate at 55°C under the
condition of 200LFM. In order to maintain effi-
cient heat dissipation, the converters should be
mounted parallel with the air-flow direction.
If the input meets extra-low voltage (ELV)
requirements, then the converter's output is
considered ELV.
Soldering
APA06 series converters are compatible with
standard wave soldering techniques. When
wave soldering, the converter pins should be
preheated for 20-30 seconds at 110°C, and
wave soldered at 260°C for less than 10 sec-
onds.
The input to these units is to be provided
with a maximum 10A normal blow fuse in
the ungrounded lead.
APA06G05(E-6) and APA6F05(E-6) need 15A
fuse.
When hand soldering, the iron temperature
should be maintained at 425°C and applied to
the converter pins for less than 5 seconds.
Longer exposure can cause internal damage to
the converter. Cleaning can be performed with
cleaning solvent IPA or with water.
Recommended Hole Pattern
Dimensions are in millimeters (inches). Component-side footprint.
63.5 (2.50)
7.1
(0.28)
48.3 (1.90)
2.79
8.38
(0.33)
(0.110)
2.54
(0.100)
J1-1
J2-6
9.1
Keep Out
(0.36)
1.17 (0.046) Plated-through Hole
1.78 (0.070) Pad Size Both Sides
Max. height
Fig.6 Recommended Hole Pattern
Mechanical Chart (Figure 7-9 next page)
-12-
USA
1-760-930-4600
1-760-930-0698
Europe
44-(0)1384-842-211
44-(0)1384-843-355
Asia
852-2437-9662
852-2402-4426
TEL:
FAX:
www.astec.com
ASTEC [ Astec America, Inc ]
