DS1100SLPE Data Sheet
Electrical Specifications
Protections
Main Output
MIN
107%
13.5 V
NOM
MAX
130%
15.0 V
Overcurrent protection2
Overvoltage protection1
Overtemperature protection
Fan fault protection
Standby Output
Yes, autorecovery
Yes
Over-current protection3:
Over-voltage protection1
1 Latch mode
110%
3.6 V
150%
3.9 V
2 No shutdown if the overcurrentis within the range and does notlast for more than 200 ms, otherwise latch will occur
3 Autorecovery
Control and Status Signals
Input Signals
PSON_L
Active LOW signal which enables/disables the main output. Pulling this signal LOW will turn-on the main output.
Recommended pull-up resistor to VSB is 5.1 kohms. A 100 pF decoupling capacitor is also recommended.
MIN
MAX
VIL
Input logic level LOW
0.8 V
3.6 V
VIH
Input logic level HIGH
2.0 V
ISOURCE
ISINK
Current that may be sourced by this pin
Current that may be sunk by this pin at low state
2 mA
0.5 mA
PSKILL_H
First break/last mate active LOW signal which enables/disables the main output. This signal will have to be pulled to ground at the system side with a 220 ohm
resistor. A 100 pF decoupling capacitor is also recommended.
MIN
MAX
0.8 V
VIL
Input logic level LOW
VIH
Input logic level HIGH
2.0 V
3.6 V
ISOURCE
Current that may be sourced by this pin
Current that may be sunk by this pin at low state
2 mA
ISINK
0.5 mA
VSENSE+, VSENSE-
VSENSE+ and VSENSE- lines are the remote sense lines for regulation. Each line will compensate for a maximum of 100 mV
Ordering Information
Model Number
Nominal Main Output
Standby Output
3.3 V @ 3 A
Airflow Direction
Std (forward)
Reverse1
DS1100SLPE-3
12 V
12 V
DS1100SLPE-3-001
3.3 V @ 3 A
1 Derating may apply.
I2C Addressing
A1 Pin
A0 Pin
PMBus (w/r)
B0/B1
0
0
1
1
0
1
0
1
B2/B3
B4/B5
B6/B7
ARTESYN [ ARTESYN TECHNOLOGIES ]
