Technical R f rence Note
Technical Reference Note
Rev.04.19.16_#1.0
ADNB 40W Series
Page 21
Output Ripple and Noise Measurement
The setup outlined in the diagram below has been used for output voltageripple and noise measurements on the ADNB
40W series . When measuring output ripple and noise, a scope jack in parallel with a 0.1uF ceramic chip capacitor, and a
47uF aluminum electrolytic capacitor should be used. Oscilloscope should be set to 20MHz bandwidth for this
measurement.
For more information: www.artesyn.com/power
For support: productsupport.ep@artesyn.com