欢迎访问ic37.com |
会员登录 免费注册
发布采购

A2530E24A 参数 Datasheet PDF下载

A2530E24A图片预览
型号: A2530E24A
PDF下载: 下载PDF文件 查看货源
内容描述: AIR BoosterPack USERA ????手册 [AIR BoosterPack User’s Manual]
分类和应用:
文件页数/大小: 45 页 / 3561 K
品牌: ANAREN [ ANAREN MICROWAVE ]
 浏览型号A2530E24A的Datasheet PDF文件第5页浏览型号A2530E24A的Datasheet PDF文件第6页浏览型号A2530E24A的Datasheet PDF文件第7页浏览型号A2530E24A的Datasheet PDF文件第8页浏览型号A2530E24A的Datasheet PDF文件第10页浏览型号A2530E24A的Datasheet PDF文件第11页浏览型号A2530E24A的Datasheet PDF文件第12页浏览型号A2530E24A的Datasheet PDF文件第13页  
AIR BoosterPack – User’s Manual  
Page 9 of 45  
Release Date 11/2/12  
2.1. Hardware Installation  
2.1.1. AIR BoosterPack with MSP430 LaunchPad  
The following steps need to be performed on each LaunchPad/BoosterPack:  
1) If not already populated, solder both 10-pin male headers provided in the LaunchPad kit  
onto the LaunchPad’s J1 and J2 breakout connections.  
2) Configure UART jumper settings on the LaunchPad.  
a. For LaunchPad Rev1.4 and earlier, remove jumpers TXD and RXD from J3 and  
install crossover jumpers (not included) onto the same group of pins to make the  
following connections:  
i. Connect J3.3 to J3.6  
ii. Connect J3.5 to J3.4  
b. For LaunchPad Rev1.5 and later, change the orientation of the J3 TXD and RXD  
jumpers to use the HW UART.  
3) Ensure the VCC jumper is populated on J3. Jumpers RST and TEST also need to be  
installed when programming the microcontroller or when debugging software.  
4) Remove the existing MSP430 device on the LaunchPad as the BoosterPack comes with  
a microcontroller already installed. Alternatively, the provided microcontroller may be  
installed in the LaunchPad’s socket. In either case, only one device should be installed  
at any given time. See Figure 4 and Figure 5 which show the two options for MSP430  
location.  
5) Install the AIR BoosterPack onto the LaunchPad board. Ensure the BoosterPack is  
oriented correctly. J1 of the BoosterPack must connect to J1 of the LaunchPad. The  
same is true for J2.  
Figure 3 Installed BoosterPack (MSP430 LaunchPad)