AAT3158
High Efficiency 1X/1.5X/2X Charge Pump
for White LED Applications
forget it." With its high-speed serial interface (1MHz
1MHz, or much slower, such as 15kHz. After data
is submitted, EN/SET is held high to latch the data.
Once EN/SET has been held in the logic high state
for time TLAT, the programmed current becomes
active and the internal data register is reset to zero.
For subsequent current level programming, the
number of rising edges corresponding to the
desired code must be entered on the EN/SET pin.
data rate), the input sink current of the AAT3158 can
be changed successively to brighten or dim LEDs in
smooth transitions (e.g., to fade-out) or in abrupt
steps, giving the user complete programmability and
real-time control of LED brightness.
S2Cwire Serial Interface
When EN/SET is held low for an amount of time
greater than TOFF, the AAT3158 enters into shutdown
mode and draws less than 1µA from VIN. The internal
data register is reset to zero during shutdown.
The current level magnitude is controlled by
AnalogicTech's Simple Serial Control (S2Cwire)
serial interface. The interface records rising edges
of the EN/SET pin and decodes them into 16 differ-
ent states. The 16 current level settings available
are indicated in Table 1.
Auto-Disable Feature
The AAT3158 is equipped with an auto-disable fea-
ture for each LED channel. After the IC is enabled
and started up, a test current of 100µA (typical) is
forced through each sink channel. The channel will
be disabled if the voltage of that particular SINK pin
does not drop to certain threshold. This feature is
very convenient for disabling an unused channel or
during an LED fail short event.
Output
Output
Data
(mA/Ch)
Data
(mA/Ch)
1
2
3
4
5
6
7
8
20
18
9
6
4
10
11
12
13
14
15
16
16
3
14
2
12.5
11
1
0.5
0.1
0.05
9.5
8
Thermal Protection
The AAT3158 has built-in thermal protection circuit
that will shut down the charge pump if the die tem-
perature rises above the thermal limit, as is the
case during a short circuit of the VOUT pin.
The S2Cwire serial interface has flexible timing.
Data can be clocked-in at speeds greater than
S2Cwire Serial Interface Timing
THI
TOFF
TLO
TLAT
EN/SET
1
2
n
n <= 16
1
n
Data Reg
0
3158.2006.02.1.0
9
ANALOGICTECH [ ADVANCED ANALOGIC TECHNOLOGIES ]
