AAT2506
1MHz Step-Down Converter/LDO Regulator
Figure 3: AAT2506 Evaluation Board Top Side.
Figure 4: AAT2506 Evaluation Board
Bottom Side.
In applications where the input power source lead
inductance cannot be reduced to a level that does
not affect the converter performance, a high ESR
tantalum or aluminum electrolytic should be placed
in parallel with the low ESR, ESL bypass ceramic.
This dampens the high Q network and stabilizes
the system.
Once the average inductor current increases to the
DC load level, the output voltage recovers. The
above equation establishes a limit on the minimum
value for the output capacitor with respect to load
transients.
The internal voltage loop compensation also limits
the minimum output capacitor value to 22µF. This is
due to its effect on the loop crossover frequency
(bandwidth), phase margin, and gain margin.
Increased output capacitance will reduce the
crossover frequency with greater phase margin.
Output Capacitor
The output capacitor limits the output ripple and
provides holdup during large load transitions. A
22µF X5R or X7R ceramic capacitor typically pro-
vides sufficient bulk capacitance to stabilize the
output during large load transitions and has the
ESR and ESL characteristics necessary for low
output ripple.
The maximum output capacitor RMS ripple current
is given by:
1
V
OUT · (VIN(MAX) - VOUT
)
IRMS(MAX)
=
·
L · F · VIN(MAX)
2 · 3
The output voltage droop due to a load transient is
dominated by the capacitance of the ceramic out-
put capacitor. During a step increase in load cur-
rent, the ceramic output capacitor alone supplies
the load current until the loop responds. Within two
or three switching cycles, the loop responds and
the inductor current increases to match the load
current demand. The relationship of the output volt-
age droop during the three switching cycles to the
output capacitance can be estimated by:
Dissipation due to the RMS current in the ceramic
output capacitor ESR is typically minimal, resulting in
less than a few degrees rise in hot-spot temperature.
Adjustable Output Resistor Selection
For applications requiring an adjustable output volt-
age, the 0.6V version can be externally pro-
grammed. Resistors R1 and R2 of Figure 5 program
the output to regulate at a voltage higher than 0.6V.
To limit the bias current required for the external
feedback resistor string while maintaining good
noise immunity, the minimum suggested value for
3 · ∆ILOAD
=
COUT
VDROOP · FS
2506.2005.12.1.0
17
ANALOGICTECH [ ADVANCED ANALOGIC TECHNOLOGIES ]
