欢迎访问ic37.com |
会员登录 免费注册
发布采购

AS1713 参数 Datasheet PDF下载

AS1713图片预览
型号: AS1713
PDF下载: 下载PDF文件 查看货源
内容描述: 差分放大器的10MHz , 10V / μs的轨至轨I / O [Difference Amplifier, 10MHz, 10V/μs, Rail-to-Rail I/O]
分类和应用: 放大器
文件页数/大小: 15 页 / 1738 K
品牌: AMSCO [ AMS(艾迈斯) ]
 浏览型号AS1713的Datasheet PDF文件第7页浏览型号AS1713的Datasheet PDF文件第8页浏览型号AS1713的Datasheet PDF文件第9页浏览型号AS1713的Datasheet PDF文件第10页浏览型号AS1713的Datasheet PDF文件第11页浏览型号AS1713的Datasheet PDF文件第13页浏览型号AS1713的Datasheet PDF文件第14页浏览型号AS1713的Datasheet PDF文件第15页  
AS1713  
Data Sheet - Application Information  
Figure 26. Rail-to-Rail Input / Output Range;  
Figure 27. Rail-to-Rail Input / Output Range;  
VIN = VDD = 3.0V, RLOAD = 100kΩ  
VIN = VDD = 3.0V, RLOAD = 32Ω  
2µs/Div  
2µs/Div  
Note: The absolute maximum ratings (see page 3) for power dissipation and output short-circuit duration (10s, max)  
must be adhered since the output current can exceed 200mA (see Typical Operating Characteristics on page  
6).  
Shutdown  
When EN is pulled to low, the supply current drops to 0.5µA, the amplifier is disabled and the output is driven to VSS.  
Pulling EN to high enables the amplifier. When exiting shutdown, there is a 6µs delay before the amplifier output  
becomes active.  
Note: Because the output is actively driven to VSS in shutdown, any pullup resistor on the output causes a current  
drain from the supply.  
Power-Up  
The AS1713 typically settle within 5µs after power-up.  
Power Supplies and Layout  
The AS1713 can operate from a single 2.7V to 5.5V supply or from dual ±1.35V to ±2.5V supplies. Good design  
improves device performance by decreasing the amount of stray capacitance at the op amp inputs/outputs.  
For single-supply operation, bypass the power supply with a 0.1µF ceramic capacitor.  
For dual-supply operation, bypass each supply to ground.  
Decrease stray capacitance by placing external components close to the op amp pins, minimizing trace and lead  
lengths.  
www.austriamicrosystems.com  
Revision 1.01  
12 - 15