AS1363
Datasheet - Pinout
4 Pinout
Pin Assignments
Figure 2. Pin Assignments (Top View)
IN
POK
EN
1
2
3
6
5
4
OUT
AS1363
SET/BYP
GND
Pin Descriptions
Table 2. Pin Descriptions
Pin Number
Pin Name
Description
+2.0V to +5.5V Supply Voltage. Bypass this pin with a 1µF capacitor to GND (see
Capacitor Selection and Regulator Stability on page 11).
1
IN
Open-Drain POK Output. POK remains low while VOUT is below the POK
threshold. Connect a 100kΩ pull-up resistor from this pin to OUT to obtain an output
voltage (see Figure 1 on page 1).
2
POK
Active-High Enable Input. A logic low reduces supply current below 30nA. In
shutdown mode, the POK output is low, and OUT is high impedance. Connect this
pin to IN for normal operation.
3
4
EN
Ground
GND
SET
Voltage-Setting Input. Connect to GND for preset output or Connect to a resistive
voltage-divider between OUT and GND to set the output voltage between 1.2V and
5.3V (see Figure 1 on page 1).
Bypass Pin. Connect a 10nF capacitor from this pin to VOUT to improve PSRR and
noise performance (see Figure 16 on page 9).
5
6
BYP
OUT
Output. Sources up to 500mA. Bypass this pin with a 2.2µF low-ESR capacitor to
GND (see Figure 1 on page 1).
Note: For output voltages below 2V a 4.7µF capacitor should be used.
www.austriamicrosystems.com
Revision 1.03
2 - 14