Datasheet
AS1302
5V/30mA Adaptive Inductorless Boost Converter
1 General Description
2 Key Features
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Up to 90% Efficiency
The AS1302 is a 30mA inductorless boost converter
using a double H-bridge charge-pump topology with two
external flying capacitors. The AS1302 charge pump
features 1:2 and 2:3 operation modes as well as a 1:1
operation mode where the input is directly connected to
the output.
2.9V to 5.15V Input Voltage
Regulated 5V Output
Automatic Mode Switching
<1µA Shutdown Current
Startup with Full Load (within 1ms)
Up to 30mA Load Current
Short Circuit Protection
Output Disconnected During Shutdown
Soft-Start
The AS1302 runs on a 1.2MHz fixed frequency and is
utilized with a low noise regulation scheme to allow
usage together with sensitive RF circuitry from the same
battery supply. Additionally to increase efficiency the
AS1302 switches to 49kHz at light loads.
Designed to reside in portable and space limited
equipment the 1.2MHz charge pump converts a 2.9V to
5.15V input to regulated 5V output with 3% accuracy.
No Inductor Required
Small External Components Required
(COUT =2.2µF, CFLY =220nF)
The shutdown function reduces the supply current to
<1µA and disconnects the load from the output. The
integrated soft-start circuitry prevents high inrush
currents being drawn from the battery during start-up.
ꢀ
Low Noise Fixed Frequency (1.2MHz, 49kHz)
Charge Pump:
- 1:1 Battery Feed Through Mode
- 2:3 Single Phase Mode
- 1:2 Single Phase Mode
Package Options:
The AS1302 includes built-in under-voltage lockout,
short circuit-, and thermal protection circuitry.
The AS1302 is available in TDFN (3x3x0.8mm) 10-pin
and an extremely small 1.2x1.2mm WL-CSP 8-bumps
package with 0.4mm pitch.
ꢀ
- TDFN (3x3x0.8mm) 10-pin
- WL-CSP 8-bumps with 0.4mm Pitch
3 Applications
The device is ideal for two or three AA cells or a single
Li-Ion battery cell to 5V conversion, mobile phones,
portable instruments, microprocessor based systems
and remote data-acquisition systems.
Figure 1. AS1302 - Typical Application Diagram
CFLY1
C1+
220nF
C1-
VOUT = 5V
VBATT
2.9V to 5.15V
VBATT
EN
VOUT
GND
CBAT
2.2µF
COUT
2.2µF
AS1302
On
Off
C2+
C2-
220nF
CFLY2
www.austriamicrosystems.com/DC-DC_Step-Up/AS1302
Revision 1.03
1 - 18
AMSCO [ AMS(艾迈斯) ]
